IRIS+™ Guides

Axis Edge™ Installation Guide

1min

A step-by-step guide to install the IRIS+™ Edge™ for AXIS application onto your camera and connect it to the IRIS+™ Portal.

Get the application installation file from Irisity customer support: [email protected]

  1. Camera interface
    1. Login to the camera

    2. Ensure that DNS is configured in the network settings so that outside services can be reached.

      Document image
      
  2. Install app

    1. Select apps

      Document image
      
    2. Add app (+)

    3. Select the app package file that you received from Irisity's Customer Support

      Document image
      
    4. Press "Install"

    5. Toggle start and press "Open"

      Document image
      

    6. Enter username and password for an IRIS+ account administrator.

      Document image
      
    7. Press Register

    8. If multi-factor authentication is enabled for the IRIS+ account, enter the authentication code.

      Document image
      
    9. Press "Confirm"
  3. Setup Edge device in IRIS+

    1. Select IRIS+ account folder

      Document image
      
    2. Enter the desired device name
    3. Press "Save"
  4. Calibration While the Irisity Edge for Axis app is built to require only minimal configuration, the algorithm does still need an approximation of the 3D ground plane visible in the camera. This is done by doing a calibration for the camera in the IRIS+ portal. When defining an alarm zone by adding a rule in the IRIS+ portal, “inside” the zone is defined as the bottom center point of the object being inside the zone, the feet of a pedestrian for example. The number of seconds an alarm zone will be deactivated after an alarm has been triggered can be adjusted by the “Minimum time between events” camera setting in the IRIS+ portal. There is also an event cooldown which is the number of seconds an alarm will disable further detections from the same alarming object, including nearby objects that is fixed to 300 seconds.

    1. Select a camera in the tree.

      Document image
      
    2. Select "Calibration"
    3. Press "Calibration settings"

    4. Add and adjust markers

      Document image
      
    5. Press "Save"
  5. Define rules
    1. Select "Logical view"

    2. Select camera

      Document image
      
    3. Select "Rules"
    4. Press "+Add"

    5. Enter rule name

      Document image
      
    6. Select object types to detect. People, Vehicles, or both
    7. Adjust alarm zone
    8. Press Save
  6. Events and alarms
    After successfully installing the app and configuring the camera in the IRIS+ portal, objects classified as human activity breaching the alarm zone while not in a cooldown will produce alarm events.



PREVIOUS
Edge™ CI Server Installation guide
NEXT
IRIS+™ Architecture and Engineering
Docs powered by Archbee